📞 02129099810
EnergyPlus
← Back to Products
1 / 2

EnergyPlus

Modbus TCP/RTU GSM Gateway

SKU: EPL-GSM-100

A Modbus TCP/RTU gateway with an integrated GSM modem for remote monitoring, control and alarm notification over SMS.

Price on Request

● Out of Stock

Please contact us for pricing on this product.

Description

SCADA systems, HMI panels and BMS software send Modbus TCP requests over Ethernet; the EPL-GSM-100 delivers them as Modbus RTU to PLCs, meters, sensors and actuators on the RS-485 line. Its integrated GSM modem lets it work at sites with no fixed Internet connection: authorised operators send an SMS to query status or issue control commands, and the gateway sends an SMS alert on its own when it detects an alarm condition on the Modbus network. KEY FEATURE Remote monitoring and control over a GSM modem; Modbus TCP/RTU conversion for up to 32 slave devices on the RS-485 port. ADVANTAGES • Remote control where the network ends — With no Internet on site, an authorised operator sends an SMS command and receives data or triggers a control action within seconds; no site visit required. • Alerts before the phone rings — Configured alarm rules send an SMS the moment a fault is detected, and a recovery message when it clears. • Browser-based configuration — Network settings, Modbus port parameters, authorised SMS numbers, alarm rules and the slave list are managed from the built-in web interface. • Self-recovering operation — Slave health monitoring (response time, success rate), timestamped error log (last 50 entries), hardware and software watchdogs. TECHNICAL SPECIFICATIONS Brand / origin: Energyplus / Türkiye Firmware version: V1.0.46 Supply voltage: 24 VDC ±5% Power consumption: ≤ 3 W Communication Modbus TCP ↔ Modbus RTU protocol conversion RS-485: 1 independent port (COM 1: A-B-G + S built-in 120 Ω line termination), 32 slave devices Ethernet: RJ45 (LAN-1) with link/activity LEDs; static IP or DHCP GSM: integrated GSM/GPRS modem (quad-band 2G), Micro-SIM (2FF) slot, SMA antenna connector SMS: command reception (query and control), alarm and recovery notifications Web interface: default address 192.168.1.192 Firmware: remote update over Ethernet (OTA) Indicators Green LED: system running normally · Blue LED: GSM modem activity (registration / data / SMS) Dimensions and mounting Dimensions: 90 × 70 × 32 mm · Weight: 200 g Mounting: DIN rail (TS35), inside a panel SCOPE OF DELIVERY 1 × EPL-GSM-100 · 1 × plug-in terminal set · 1 × GSM antenna (SMA) INSTALLATION NOTES • Before powering up, insert a Micro-SIM card with SMS service enabled and connect the GSM antenna. • Wire the RS-485 line to the A, B and G (GND) terminals of COM 1; do not swap A and B. The S terminal is the 120 Ω line termination: both ends of the line must be terminated, so use S if the unit is at the end of the line. Earth the cable shield at one point only. • Change the factory password of the web interface during commissioning.